Digibell Vandal Resistant System Guía de instalación descargar pdf (Pagina 22)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 22 of 56

Entrance Panel Programming

Several useful settings can be changed using the Entrance panel. This includes.

• Lock duration

• Lock type

• Tradesman and Coded Access Codes

(see Table below for full list)

Security

It is strongly recommended that the Panel Security Code (PSEC) be changed from its factory

setting to prevent unauthorized access. Record the new number carefully as it cannot be

easily changed if lost. It is also recommended that the Phone Programming Code (PPRG),

Coded Access Code (ACOD) and Trades Access Code (TCOD) are all changed from default

even if not used.

To access panel programming without the code requires physical access to the controller

associated BSD-DIG PCB, borrow a jumper from say video gain and place it on the 5 pin

programming header between pins 1 & 2 (pin 1 is marked). Now pressing the test button will

enter panel programming for 30S when the panel security code can be read or set. When

the programming is finished replace the jumper back to its original location.

Using Panel Programming Mode:-

• First type the Panel Security Code (initially 3434) followed by the call button.

• The display will show the first programmable parameter (ACOD),

(The display alternates, at 1 sec. Intervals, between the parameter name and its value.)

• Press the Trades button to step down through the programmable parameters.

• Press the Reception button to step up through the programmable parameters.

• The list rolls over bottom to top and vice versa.

• To change a numeric parameter simply type a new 1-4-digit value and then press call.

• Some parameters have a list of options; simply press call to choose the next value.

• To exit Panel Program Mode press cancel.

• If no button is pressed for 30S then programming mode will auto-cancel.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Sin comentarios

Digibell Vandal Resistant System Guía de instalación Pagina 22