Digibell Vandal Resistant System Guía de instalación descargar pdf (Pagina 39)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 39 of 56

Ringer volume

This model has 2 ring levels ‘Low’, ‘Medium’ and ‘High’, the default is ‘High’. It the ringer is

too loud move the jumper marked ‘Ring Volume’ on the PCB to the ‘Medium’ or ‘Low’

position.

Ringer mute time

The phone can be set so that after pressing the mute button the ringer is disabled for a set

time and then automatically re-enables itself. This time is adjustable between 2 minutes and

10 hours. It can typically be used to silence the ringer over night. The default setting disables

the ringer until the button is pressed again (not cancelling automatically). Refer to the table

above or the label inside the phone.

The settings for ‘Ring type’, ‘Door Monitor’ and ‘Unlock time’ should be left on the defaults

(DIP switch 1-4 should be all OFF) as they are not used on the Digibell system.

Phone connections

Terminal

Meaning

I Call (12V to ring)

R Microphone speech

O Common for ring, speech and lock button (0V)

T Speaker

Z Lock button (Z shorts to O when the lock button is pressed)

V 12V Phone supply (BS-LX only)

L Door Monitor (connecting L to 0V brings green LED on, BS-LX

only)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Sin comentarios

Digibell Vandal Resistant System Guía de instalación Pagina 39