Digibell Vandal Resistant System Guía de instalación descargar pdf (Pagina 30)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 30 of 56

Example:

If the 1

floor has flats 1, 2, 3 and the 2

floor has flats 4, 5, 6 and one Isolator is used for

each floor. The 4

Phone output on the 1

floor Isolator will need disabling; otherwise two

outputs will try to ring flat 4.

Special addressing

On the rare occasion when flat numbers skip every other number, e.g. 1,3,5,7 or 2,4,6,8 etc

the jumper on the ‘PROG’ 6 pin header can be moved to pins 3 and 4.

If flat numbers are required in the range 3200 to 6400 the jumper on the ‘PROG’ 6 pin header

can be moved to pins 5 and 6. This simply adds an offset of +3200 to any address set on

SW6 and SW7.

Alphanumeric Flat Numbers

Flat numbers requiring alphabetic characters (e.g. A1-A8, B101-B108, 101C-108C) cannot

be programmed on the Isolators and must be programmed into each individual telephone.

Please contact Bell System for instructions in this case.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 55 56

Sin comentarios

Digibell Vandal Resistant System Guía de instalación Pagina 30